LEMON Manuals: Even more car manuals for everyone
Home >> Nissan-Datsun >> 2004 >> Altima S, Standard >> Repair and Diagnosis >> External Pages >> Different car >> Section 1022 (Brake System) >> On-Vehicle Repair >> Vacuum Lines >> Removal and Installation >> Installation

Removal and Installation: Installation

WARNING: This page is about a different car, the 2009 Nissan Maxima. However, it is still accessible from the selected car via links, so may be relevant.

Installation is in the reverse order of removal.

CAUTION:
  • Because the vacuum hose contains a check valve, the vacuum hose must be installed in the correct position for proper operation. Refer to the stamp on the end of the vacuum hose to confirm correct installation. The brake booster will not operate normally if the vacuum hose with the check valve is installed in the wrong direction.
  • Insert the vacuum pipe into the vacuum hose at least 24 mm (0.94 in) as shown.
  • Do not use lubricating oil during installation.
    Fig 1: Applying Oil Or Lubricants To Vacuum Hose With Check Valve
    G04876661Courtesy of NISSAN MOTOR CO., U.S.A.
scientia non olet · About LEMON Manuals