LEMON Manuals: Even more car manuals for everyone
Home >> Nissan-Datsun >> 2004 >> Altima S, Standard >> Repair and Diagnosis >> External Pages >> Different car >> Section 1022 (Brake System) >> On-Vehicle Repair >> Brake Pedal >> Removal and Installation >> Removal

Removal and Installation: Removal

WARNING: This page is about a different car, the 2009 Nissan Maxima. However, it is still accessible from the selected car via links, so may be relevant.
  1. Remove instrument lower cover (LH) and lower knee protector. Refer to "EXPLODED VIEW ".
  2. Remove the accelerator pedal assembly. Refer to "REMOVAL AND INSTALLATION ".
  3. Disconnect stop lamp switch and ASCD switch connector.
  4. Remove stop lamp switch and ASCD switch from brake pedal assembly.
  5. Remove snap pin and clevis pin from brake booster clevis.
  6. Disconnect the steering column upper joint and reposition it out of the way.
  7. Remove brake pedal assembly to brake booster nuts. Pull brake booster toward engine room to the extent that does not deform the brake tubes.
    WARNING: Do not bend the brake tubing.
  8. Remove brake booster clevis from input rod.
  9. Remove top nut and then remove brake pedal assembly.
    • Temporarily install the brake pedal assembly to brake booster nuts by hand to support the brake booster.
    CAUTION: Avoid damage from dropping the brake pedal assembly during handling.
scientia non olet · About LEMON Manuals