Inspection Procedure
WARNING: This page is about a different car, the 2009 Nissan Maxima. However, it is still accessible from the selected car via links, so may be relevant.
- CHECK BATTERY TERMINALS CONNECTION
Check if battery terminals are clean and tight.
Is the inspection result normal?
YES: GO TO 2
NO: Repair battery terminals connection.
- CHECK FUSE
Check for blown fuse and fusible link.
FUSE AND FUSIBLE LINK REFERENCEUnit Power source (Power supply terminals) Fuse or Fusible Link Generator Battery (terminal 3) Fuse 29 Battery (terminal 1) Fusible Link A Combination meter Ignition switch ON (terminal 2) Fuse 4 Is the inspection result normal?
YES: GO TO 3
NO: Be sure to eliminate cause of malfunction before installing new fuse or fusible link.
- CHECK GENERATOR GROUND TERMINAL CONNECTION
Check if connector E230 terminal 5 (generator ground harness) is clean and tight.
Is the inspection result normal?
YES: GO TO 4
NO: Repair connection.
- CHECK DRIVE BELT TENSION
Check drive belt tension. Refer to "INSPECTION ".
Is the inspection result normal?
YES: Inspection End.
NO: Repair as needed.