Diagnosis Procedure

WARNING: This page is about a different car, the 2009 Nissan Maxima. However, it is still accessible from the selected car via links, so may be relevant.

CHECK TERMINAL "1" CONNECTION
1. Turn ignition switch OFF.
2. Check if terminal "1" is clean and tight.
Is the inspection result normal?

YES: GO TO 2

NO: Repair terminal "1" connection. Confirm repair by performing complete Starting/Charging system test. Refer to diagnostic station instruction manual.
CHECK TERMINAL "1" CIRCUIT
Check voltage between generator connector F6 terminal 1 and ground.

1 - ground: Battery voltage

Is the inspection result normal?

YES: GO TO 3

NO: Check harness for open between generator and fusible link.

Fig 1: Checking Voltage Between Generator Connector F6 Terminal 1 And Ground
Courtesy of NISSAN MOTOR CO., U.S.A.
CHECK TERMINAL "1" CONNECTION (VOLTAGE DROP TEST)

Start engine, then engine running at idle and warm.
Check voltage between battery positive terminal and generator connector F6 terminal 1.

1 - B+: Less than 0.2 V

Is the inspection result normal?

YES: Terminal "1" circuit is normal. Refer to "WORK FLOW ".

NO: Check harness between battery and generator for high resistance.

Fig 2: Checking Voltage Between Battery Positive Terminal And Generator Connector F6 Terminal 1

Courtesy of NISSAN MOTOR CO., U.S.A.