Removal and Installation (Right Side): Installation

WARNING: This page is about a different car, the 2009 Nissan Maxima. However, it is still accessible from the selected car via links, so may be relevant.

Installation is in the reverse order of removal. Note the following:

CAUTION: Do not reuse non-reusable parts.

Install new circlip on drive shaft in the circular clip groove on transaxle side. Refer to "DISASSEMBLY AND ASSEMBLY (RIGHT SIDE) ".
CAUTION: Make sure the new circlip on the drive shaft is securely fastened.
In order to prevent damage to differential side oil seal, place Tool (A) onto oil seal before inserting drive shaft as shown. Slide drive shaft into slide joint and tap with a hammer to install securely.

Fig 1: Placing Special Tool Onto Oil Seal
Courtesy of NISSAN MOTOR CO., U.S.A.

Tool number (A): KV38107900 (-)

CAUTION: Make sure that circlip is completely engaged.
When installing support bearing bracket, temporarily tighten mounting bolts, then tighten to specified torque.