Diagnosis Procedure

WARNING: This page is about a different car, the 2009 Nissan Maxima. However, it is still accessible from the selected car via links, so may be relevant.

CHECK WASHER LEVEL SWITCH SIGNAL CIRCUIT
1. Turn ignition switch OFF.
2. Disconnect combination meter connector and washer level switch connector.
3. Check continuity between combination meter harness connector M24 (A) terminal 29 and washer level switch harness connector E208 (B) terminal 1.
4. Check continuity between combination meter harness connector M24 (A) terminal 29 and ground.
29 - Ground: Continuity should not exist.

Fig 1: Checking Continuity Between Combination Meter Harness Connector M24 Terminal 29 And Ground
Courtesy of NISSAN MOTOR CO., U.S.A.

Is the inspection result normal?

YES: GO TO 2

NO: Repair harness or connector.
CHECK WASHER LEVEL SWITCH GROUND CIRCUIT
Check continuity between washer fluid level switch harness connector E208 terminal 2 and ground.

2 - Ground: Continuity should exist.

Fig 2: Checking Continuity Between Washer Fluid Level Switch Harness Connector E208 Terminal 2 And Ground
Courtesy of NISSAN MOTOR CO., U.S.A.

Is the inspection result normal?

YES: Inspection End.

NO: Repair harness or connector.