Diagnosis Procedure

WARNING: This page is about a different car, the 2009 Nissan Maxima. However, it is still accessible from the selected car via links, so may be relevant.

CHECK PARKING BRAKE SWITCH CIRCUIT
1. Disconnect combination meter connector and parking brake switch connector.
2. Check continuity between combination meter harness connector M24 (A) terminal 26 and parking brake switch harness connector E35 (B) terminal 1.
3. Check continuity between combination meter harness connector M24 (A) terminal 26 and ground.
26 - Ground: Continuity should not exist.

Fig 1: Checking Continuity Between Combination Meter Harness Connector M24 Terminal 26 And Ground
Courtesy of NISSAN MOTOR CO., U.S.A.

Is the inspection result normal?

YES: Inspection End.

NO: Repair harness or connector.