Erase Self-Diagnosis

WARNING: This page is about a different car, the 2009 Nissan Maxima. However, it is still accessible from the selected car via links, so may be relevant.

With CONSULT-III

Perform applicable inspection of malfunctioning item and then repair or replace.
Turn ignition switch "ON" and select "SELF-DIAG RESULTS" mode for "AIR PRESSURE MONITOR" with CONSULT-III.
Touch "ERASE" on CONSULT-III screen to erase memory.

Without CONSULT-III

In order to make it easier to find the cause of hard-to-duplicate malfunctions, malfunction information is stored into the control unit as necessary during use. This memory is not erased no matter how many times the ignition switch is turned "ON" and "OFF".
However, this information is erased by turning ignition switch "OFF" after performing self-diagnostic or by erasing the memory using the CONSULT-III.