LEMON Manuals: Even more car manuals for everyone
Home >> Nissan-Datsun >> 2004 >> Altima S, Standard >> Repair and Diagnosis >> External Pages >> Different car >> Section 1012 (SRS Airbag Control System) >> Function Diagnosis >> On Board Diagnostic (OBD) System >> Self-Diagnosis Function (Without CONSULT-III) >> Diagnostic Procedure 3

Diagnostic Procedure 3

WARNING: This page is about a different car, the 2009 Nissan Maxima. However, it is still accessible from the selected car via links, so may be relevant.

Final Check of SRS Using CONSULT-III - Diagnosis Mode

  1. Connect CONSULT-III.
  2. If no DTC is detected on "SELF-DIAG [CURRENT]", repair of SRS is completed. Go to step 3.

    If any DTC is detected on "SELF-DIAG [CURRENT]", the malfunctioning part has not been repaired completely or another malfunctioning part is being detected. Perform DIAGNOSTIC PROCEDURE 2. Refer to "SRS OPERATION CHECK ".

  3. Touch "ERASE".
    NOTE: Touch "ERASE" to clear the memory of the malfunction ("SELF-DIAG [PAST]").

    If the memory of the malfunction in "SELF-DIAG [PAST]" is not erased, the User mode shows the system malfunction by the operation of the warning lamp even if the malfunction is repaired completely.

  4. Touch "BACK" key of CONSULT-III. Touch "SELF-DIAG [PAST]".
  5. Check that no malfunction is detected on "SELF-DIAG [PAST]".
  6. Touch "BACK" key of CONSULT-III to return to User mode from Diagnosis mode.
  7. Turn ignition switch OFF and then turn off and disconnect CONSULT-III.
  8. Go to "SRS OPERATION CHECK ".
scientia non olet · About LEMON Manuals