LEMON Manuals: Even more car manuals for everyone
Home >> Nissan-Datsun >> 2004 >> Altima S, Standard >> Repair and Diagnosis >> External Pages >> Different car >> Section 1011 (Maintenance) >> On-Vehicle Maintenance >> Chassis And Body Maintenance >> Seat Belt, Buckles, Retractors, Anchors And Adjusters >> SEAT BELT, BUCKLES, RETRACTORS, ANCHORS AND ADJUSTERS: Inspection

SEAT BELT, BUCKLES, RETRACTORS, ANCHORS AND ADJUSTERS: Inspection

WARNING: This page is about a different car, the 2009 Nissan Maxima. However, it is still accessible from the selected car via links, so may be relevant.
CAUTION:
  • After any collision, inspect all seat belt assemblies, including retractors and other attached hardwares (i.e., anchor bolt, guide rail set). Nissan recommends to replace all seat belt assemblies in use during a collision, unless not damaged and properly operating after minor collision.

    Also inspect seat belt assemblies not in use during a collision, and replace if damaged or improperly operating.

    Seat belt pre-tensioner should be replaced even if the seat belts are not in use during a frontal collision where the driver and passenger air bags are deployed.

  • If any component of seat belt assembly is questionable, do not repair.

    Replace as seat belt assembly.

  • If webbing is cut, frayed, or damaged, replace belt assembly.
  • Never oil tongue and buckle.
  • Use a genuine NISSAN seat belt assembly.

For details, refer to "INSPECTION " in the "SEAT BELTS" article.

scientia non olet · About LEMON Manuals