DISC BRAKE: Rear Brake Rotor: Thickness

WARNING: This page is about a different car, the 2009 Nissan Maxima. However, it is still accessible from the selected car via links, so may be relevant.

Check the thickness of the disc rotor using a micrometer. Replace disc rotor if the thickness is under the wear limit.

Fig 1: Checking Thickness Of Disc Rotor Using Micrometer

Courtesy of NISSAN MOTOR CO., U.S.A.

Standard thickness: 9.0 mm (0.354 in)

Wear limit: 8.0 mm (0.315 in)

Thickness variation

(Measured at 8 positions)

: 0.015 mm (0.0006 in)