LEMON Manuals: Even more car manuals for everyone
Home >> Nissan-Datsun >> 2004 >> Altima S, Standard >> Repair and Diagnosis >> External Pages >> Different car >> Section 1011 (Maintenance) >> On-Vehicle Maintenance >> Chassis And Body Maintenance >> Disc Brake >> DISC BRAKE: Rear Brake Rotor >> RUNOUT

DISC BRAKE: Rear Brake Rotor: RUNOUT

WARNING: This page is about a different car, the 2009 Nissan Maxima. However, it is still accessible from the selected car via links, so may be relevant.
  1. Fix disc rotor to wheel hub using wheel nuts (2 or more positions).
  2. Inspect runout using dial gauge. [Measured at 10 mm (0.39 in) inside disc edge.]
    Fig 1: Inspecting Runout Using Dial Gauge
    G04887110Courtesy of NISSAN MOTOR CO., U.S.A.

    Runout limit: 0.05 mm (0.002 in) 

    (With it attached to the vehicle) 

    NOTE: Before measuring, make sure that wheel bearing axial end play is within the specification. Refer to "INSPECTION ".
  3. When runout exceeds limit value, displace mounting positions of disc rotor by one hole. And then find a position of the minimum value for runout.
  4. Replace disc rotor if it is outside repair limit after performing the above operation.
scientia non olet · About LEMON Manuals