Removal and Installation: Removal

WARNING: This page is about a different car, the 2009 Nissan Maxima. However, it is still accessible from the selected car via links, so may be relevant.

Refer to "EXPLODED VIEW " for removal procedure.

INSTALLATION

Insert hose securely until it contacts tube spool.
CAUTION: Do not apply fluid.

Fig 1: Inserting Tube To Hose
Courtesy of NISSAN MOTOR CO., U.S.A.
Install eye-bolt (1), copper washers (2) and eye-joint (assembled to high-pressure hose) (4) onto oil pump assembly (3), and then tighten it to the specified torque after tightening by hand.

CAUTION: Do not reuse copper washers.

Fig 2: Identifying Eye-Bolt, Copper Washers And Eye-Joint And Oil Pump Assembly

Courtesy of NISSAN MOTOR CO., U.S.A.