LEMON Manuals: Even more car manuals for everyone
Home >> Nissan-Datsun >> 2004 >> Altima S, Standard >> Repair and Diagnosis >> External Pages >> Different car >> Section 1008 (Instrument Panel) >> On-Vehicle Repair >> Center Console Assembly >> Removal and Installation >> Removal

Removal and Installation: Removal

WARNING: This page is about a different car, the 2009 Nissan Maxima. However, it is still accessible from the selected car via links, so may be relevant.
CAUTION: Be careful not to scratch console finishers and other parts.
  1. Position both RH and LH front seats forward.
  2. Disconnect the negative battery terminal.
  3. Remove the console side finishers RH and LH.
  4. Disconnect the console harness connectors (A).
    5. Fig 1: Identifying Console Harness Connectors
    G05878348Courtesy of NISSAN MOTOR CO., U.S.A.
  5. Remove the selector lever knob. Refer to "REMOVAL AND INSTALLATION ".
  6. Remove the CVT finisher, using a suitable tool.
  7. Remove the console screws (A).
    8. Fig 2: Identifying Console Screws
    G05878349Courtesy of NISSAN MOTOR CO., U.S.A.
  8. Remove the console screw cover, then remove the rear console screws (A) and then remove the console (1).
Fig 3: Identifying Rear Console Screws And Console
G05878350Courtesy of NISSAN MOTOR CO., U.S.A.
scientia non olet · About LEMON Manuals