LEMON Manuals: Even more car manuals for everyone
Home >> Nissan-Datsun >> 2004 >> Altima S, Standard >> Repair and Diagnosis >> External Pages >> Different car >> Section 1007 (Wiper & Washer) >> On-Vehicle Repair >> Front Wiper Drive Assembly >> FRONT WIPER DRIVE ASSEMBLY: Removal and Installation >> Removal

FRONT WIPER DRIVE ASSEMBLY: Removal and Installation: Removal

WARNING: This page is about a different car, the 2009 Nissan Maxima. However, it is still accessible from the selected car via links, so may be relevant.
  1. Turn wiper switch ON to operate wiper motor and then turn wiper switch OFF (auto stop).
  2. Remove wiper arms. Refer to "FRONT WIPER ARMS: REMOVAL AND INSTALLATION ".
  3. Remove hood ledge covers.
  4. Remove the cowl top grille. Refer to "EXPLODED VIEW ".
  5. Disconnect washer hose from the lower cowl top extension brace.
  6. Remove the lower cowl top extension brace. Refer to "REMOVAL AND INSTALLATION ".
  7. Detach the wiper drive harness clip from the wiper drive assembly frame.
  8. Remove the front wiper drive assembly bolts (A), disconnect the wiper drive motor connector (B) and remove the front wiper drive assembly (1).
Fig 1: Identifying Front Wiper Drive Assembly Bolts, Wiper Drive Motor Connector And Front Wiper Drive Assembly
G04889320Courtesy of NISSAN MOTOR CO., U.S.A.
scientia non olet · About LEMON Manuals