Diagnosis chart in auto active test mode

WARNING: This page is about a different car, the 2009 Nissan Maxima. However, it is still accessible from the selected car via links, so may be relevant.

AUTO ACTIVE TEST MODE DIAGNOSIS CHART

Symptom	Inspection contents		Possible cause
Any of the following components do not operate Parking lamps License plate lamps Tail lamps Front fog lamps (if equipped) Headlamp (HI, LO) Front wiper	Perform auto active test. Does the applicable system operate?	YES	BCM signal input circuit
		NO	Lamp or motor Lamp or motor ground circuit Harness or connector between IPDM E/R and applicable system IPDM E/R
A/C compressor does not operate	Perform auto active test. Does the magnet clutch operate?	YES	Combination meter signal input circuit CAN communication signal between combination meter and ECM CAN communication signal between ECM and IPDM E/R
A/C compressor does not operate	Perform auto active test. Does the magnet clutch operate?	NO	Magnet clutch Harness or connector between IPDM E/R and magnet clutch IPDM E/R
Oil pressure warning lamp does not operate	Perform auto active test. Does the oil pressure warning lamp blink?	YES	Harness or connector between IPDM E/R and oil pressure switch Oil pressure switch IPDM E/R
Oil pressure warning lamp does not operate		NO	CAN communication signal between IPDM E/R and BCM CAN communication signal between BCM and combination meter Combination meter
Cooling fan does not operate	Perform auto active test. Does the cooling fan operate?	YES	ECM signal input circuit CAN communication signal between ECM and IPDM E/R
Cooling fan does not operate	Perform auto active test. Does the cooling fan operate?	NO	Cooling fan Harness or connector between cooling fan and cooling fan relays Cooling fan relays Harness or connector between IPDM E/R and cooling fan relays IPDM E/R