Clip Replacement: Installation
WARNING: This page is about a different car, the 2009 Nissan Maxima. However, it is still accessible from the selected car via links, so may be relevant.
- Clean tape removed surface with a shop cloth soaked in white gasoline or IPA.
- Use two-part epoxy adhesive.
Adhesive: 3M-weld DP-100 or equivalent
- Apply adhesive evenly to clip tape surface.
Thickness: Approximately 0.5 mm (0.020 in)
- Position applied parts to the proper location, and then sufficiently press-fit until the adhesive protrudes to tape side.
Press-fit limit: 19.6 N.x 2 secondsx
- Tape clips after press fit, and temporarily hold it for specified time based on the following.
5 to 10°C (41 to 50°F): 1 hour or more
11 to 23°C (52 to 73°F): 30 minutes or more
24°C or more (75°F or more): 15 minutes or more
- Install roof side molding rear edge first, working toward front after temporarily holding.
CAUTION:
- Securely insert molding rear end cap onto roof rear end cutout (installation standard).
- When installing roof side molding, check that molding fastener is securely inserted and then press in.
- Do not wash the vehicle within 24 hours after repair.