LEMON Manuals: Even more car manuals for everyone
Home >> Nissan-Datsun >> 2004 >> Altima S, Standard >> Repair and Diagnosis >> External Pages >> Different car >> Section 1005 (Exterior Trim & Body Panels) >> On-Vehicle Repair >> Rear Bumper >> Removal and Installation >> Removal

Removal and Installation: Removal

WARNING: This page is about a different car, the 2009 Nissan Maxima. However, it is still accessible from the selected car via links, so may be relevant.
  1. Remove trunk floor carpet, side finishers, and rear finisher. Refer to "EXPLODED VIEW ".
  2. Remove the rear combination lamps RH/LH. Refer to "REMOVAL AND INSTALLATION ".
  3. Remove rear wheel RH/LH, then remove rear fender protector RH/LH. Refer to "REMOVAL AND INSTALLATION ".
  4. Remove rear bumper fascia clips and screws, then remove the rear bumper fascia.
  5. Remove rear energy absorbing foam.
  6. Remove the rear bumper reinforcement bolts, then remove rear bumper reinforcement.
  7. Remove the rear bumper support bolts, then remove the rear bumper supports RH/LH.
scientia non olet · About LEMON Manuals