LEMON Manuals: Even more car manuals for everyone
Home >> Nissan-Datsun >> 2004 >> Altima S, Standard >> Repair and Diagnosis >> External Pages >> Different car >> Section 1005 (Exterior Trim & Body Panels) >> On-Vehicle Repair >> License Lamp Finisher >> Removal and Installation >> Removal

Removal and Installation: Removal

WARNING: This page is about a different car, the 2009 Nissan Maxima. However, it is still accessible from the selected car via links, so may be relevant.
  1. Remove the trunk lid finisher. Refer to "EXPLODED VIEW ".
  2. Disconnect the trunk request switch connector (1).
  3. Remove the license lamp finisher nuts.
  4. Release the clips, then loosen trunk request switch harness grommet from trunk.
  5. Remove license lamp finisher by pulling out and rearward away from trunk.
Fig 1: Identifying Trunk Request Switch Connector
G05878406Courtesy of NISSAN MOTOR CO., U.S.A.
scientia non olet · About LEMON Manuals