LEMON Manuals: Even more car manuals for everyone
Home >> Nissan-Datsun >> 2004 >> Altima S, Standard >> Repair and Diagnosis >> External Pages >> Different car >> Section 1005 (Exterior Trim & Body Panels) >> On-Vehicle Repair >> Front Bumper >> Removal and Installation >> Removal

Removal and Installation: Removal

WARNING: This page is about a different car, the 2009 Nissan Maxima. However, it is still accessible from the selected car via links, so may be relevant.
  1. Release the core support cover clips, then remove the core support cover.
  2. Release the engine under cover clips, then remove engine under cover.
  3. Remove the front fender protector side covers RH/LH. Refer to "REMOVAL AND INSTALLATION ".
  4. Remove the front fender protector clips and screws from the front edge and partially remove, pulling them away for access.
  5. Remove the front bumper fascia clips and screws, then remove front bumper fascia.
  6. Remove the fog lamps if equipped. Refer to "REMOVAL AND INSTALLATION ".
  7. Remove the front grille. Refer to "REMOVAL AND INSTALLATION ".
  8. Remove the front energy absorbing foam.
  9. Disconnect the harness connector, then remove the ambient temperature sensor.
  10. Remove the upper fascia support bolts, then remove upper fascia support.
  11. Remove the front bumper reinforcement bolts, then remove front bumper reinforcement.
  12. Remove the front bumper stay bolts, then remove the RH/LH front bumper stays.
scientia non olet · About LEMON Manuals