LEMON Manuals: Even more car manuals for everyone
Home >> Nissan-Datsun >> 2004 >> Altima S, Standard >> Repair and Diagnosis >> External Pages >> Different car >> Section 1004 (Tires, Wheels & Tire Pressure Monitoring System (TPMS)) >> Basic Inspection >> Inspection And Adjustment >> ID Registration Procedure >> Id Registration Without Transmitter Activation Tool

Id Registration Without Transmitter Activation Tool

WARNING: This page is about a different car, the 2009 Nissan Maxima. However, it is still accessible from the selected car via links, so may be relevant.
NOTE: This procedure must be done after replacement of a low tire pressure warning transmitter or BCM. New replacement transmitters are provided "asleep" and must first be "woken up" using Transmitter Activation Tool J-45295 before ID registration can be performed.
  1. Connect CONSULT-III.
  2. Select "ID REGIST" under BCM.
  3. Adjust the tire pressures to the values shown in the table and drive the vehicle at 40 km/h (25 MPH) or more for a few minutes.
    TIRE PRESSURE SPECIFICATION

    Tire position Tire pressure kPa (kg/cm2 , psi)
    Front LH 250 (2.5, 36)
    Front RH 230 (2.3, 33)
    Rear RH 210 (2.1, 30)
    Rear LH 190 (1.9, 27)
  4. After completing all ID registrations, press "END" to complete the procedure.
    TIRE PRESSURE SPECIFICATION

    Activation tire position CONSULT-III
    Front LH "YET"
    ↓
    "DONE"
    Front RH
    Rear RH
    Rear LH
  5. Inflate all tires to proper pressure. Refer to "TIRE ".
scientia non olet · About LEMON Manuals