Id Registration With Transmitter Activation Tool

WARNING: This page is about a different car, the 2009 Nissan Maxima. However, it is still accessible from the selected car via links, so may be relevant.

NOTE: This procedure must be done after replacement of a low tire pressure warning transmitter or BCM. New replacement transmitters are provided "asleep" and must first be "woken up" using Transmitter Activation Tool J-45295 before ID registration can be performed.

Connect CONSULT-III.
Select "ID REGIST" under BCM.
Push the transmitter activation tool against the tire near the front left transmitter. Press the button for 5 seconds.

Fig 1: Identifying Transmitter Activation Tool
Courtesy of NISSAN MOTOR CO., U.S.A.

Tool number: (J-45295)

Register the IDs in order from FR LH, FR RH, RR RH and RR LH. When ID registration of each wheel has been completed, the hazard warning lamps flash.

HAZARD WARNING LAMPS FLASH CHART

Step	Activation tire position	Hazard warning lamp	CONSULT-III
1	Front LH	2 times flashing	"YET" ↓ "DONE"
2	Front RH
3	Rear RH
4	Rear LH

After completing all ID registrations, press "END" to complete the procedure.

NOTE: Be sure to register all of the IDs in order from FR LH, FR RH, RR RH, to RR LH, or the self-diagnostic results display will not function properly.