LEMON Manuals: Even more car manuals for everyone
Home >> Nissan-Datsun >> 2004 >> Altima S, Standard >> Repair and Diagnosis >> External Pages >> Different car >> Section 1002 (Automatic Transmission (Re0F09B)) >> Removal And Installation >> Transaxle Assembly >> Removal and Installation >> Removal

Removal and Installation: Removal

WARNING: This page is about a different car, the 2009 Nissan Maxima. However, it is still accessible from the selected car via links, so may be relevant.
  1. Remove the engine and transaxle assembly and front suspension member. Refer to "REMOVAL AND INSTALLATION ".
  2. Lift with hoist and separate engine and transaxle assembly from front suspension member. Refer to "REMOVAL AND INSTALLATION ".
  3. Disconnect secondary speed sensor connector. Refer to "EXPLODED VIEW ".
  4. Disconnect CVT unit connector.
  5. Remove CVT fluid charging pipe from transaxle assembly.
  6. Disconnect starter harness connectors.
  7. Remove starter assembly. Refer to "REMOVAL AND INSTALLATION ".
  8. Remove upper rear CVT gusset bolt.
  9. Remove transaxle assembly bolts with power tool.
  10. Remove transaxle assembly from engine assembly with a hoist.
  11. Remove air breather hose. Refer to "EXPLODED VIEW ".
  12. Remove CVT fluid cooler tube from transaxle assembly.
    Fig 1: Identifying Transaxle Assembly
    G05889984Courtesy of NISSAN MOTOR CO., U.S.A.
scientia non olet · About LEMON Manuals