LEMON Manuals: Even more car manuals for everyone
Home >> Nissan-Datsun >> 2004 >> Altima S, Standard >> Repair and Diagnosis >> External Pages >> Different car >> Section 1002 (Automatic Transmission (Re0F09B)) >> On-Vehicle Repair >> Control Cable >> Removal and Installation >> Removal

Removal and Installation: Removal

WARNING: This page is about a different car, the 2009 Nissan Maxima. However, it is still accessible from the selected car via links, so may be relevant.
CAUTION: Make sure that parking brake is applied before removal/installation.
  1. Remove air duct (inlet). Refer to "REMOVAL AND INSTALLATION ".
  2. Remove air cleaner case. Refer to "REMOVAL AND INSTALLATION ".
  3. Remove control cable nut.
    • →: Control cable nut
  4. Remove control cable (1) from manual lever (A).
  5. Remove lock plate (2) from control cable.
  6. Remove control cable from bracket (3).
  7. Remove center console. Refer to "REMOVAL AND INSTALLATION ".
    Fig 1: Identifying Control Cable, Manual Lever, Lock Plate And Bracket
    G05889967Courtesy of NISSAN MOTOR CO., U.S.A.
  8. Remove control cable (1) from control device assembly (2).
    • A: Ribbed surface
    Fig 2: Identifying Control Cable And Control Device Assembly
    G05889965Courtesy of NISSAN MOTOR CO., U.S.A.
  9. Remove the bolts (A) from the iPod® support bracket (1), if equipped.
  10. Remove bracket covering the retainer grommet.
  11. Remove the retainer grommet bolts and the retainer grommet.
    Fig 3: Identifying Bolts And Support Bracket
    G05030490Courtesy of NISSAN MOTOR CO., U.S.A.
  12. Remove the control cable (1) from the vehicle.

    A: Dash trim

    →: Bolt

    Fig 4: Removing Control Cable
    G05875865Courtesy of NISSAN MOTOR CO., U.S.A.
scientia non olet · About LEMON Manuals