LEMON Manuals: Even more car manuals for everyone
Home >> Nissan-Datsun >> 2004 >> Altima S, Standard >> Repair and Diagnosis >> External Pages >> Different car >> Section 1002 (Automatic Transmission (Re0F09B)) >> On-Vehicle Maintenance >> CVT Position >> Inspection and Adjustment >> Adjustment

Inspection and Adjustment: Adjustment

WARNING: This page is about a different car, the 2009 Nissan Maxima. However, it is still accessible from the selected car via links, so may be relevant.
  1. Set the park brake.
    CAUTION: Make sure the vehicle cannot move with parking brake set.
  2. Loosen the control cable nut and place the manual lever in "P" position.
  3. Place the selector lever in "P" position.
  4. Push the control cable in with a load of 9.8 N (approximately 1 kg, 2.2 lb). Release the cable and temporarily tighten the control cable nut.
    NOTE: Do not move the manual lever. Make sure the manual lever stays in the "P" position.
  5. Tighten the control cable nut. Refer to "EXPLODED VIEW ".
    CAUTION: Secure manual lever when tightening nut.
  6. Check the operation of the CVT. Refer to "INSPECTION AND ADJUSTMENT ".
    Fig 1: Identifying Control Cable And Manual Lever
    G04916221Courtesy of NISSAN MOTOR CO., U.S.A.
scientia non olet · About LEMON Manuals