Checking CVT Fluid

The fluid level should be checked with the fluid warmed up to 50 to 80°C (122 to 176°F). The fluid level check procedure is as follows:

1. Check for fluid leakage.
2. With the engine warmed up, drive the vehicle in an urban area. When ambient temperature is 20°C (68°F), it takes about 10 minutes for the CVT fluid to warm up to 50 to 80°C (122 to 176°F).
3. Park the vehicle on a level surface.
4. Apply parking brake firmly.
5. With engine at idle, while depressing brake pedal, move shift selector throughout the entire shift range.
   Fig 1: Checking CVT Fluid Leakage

   Courtesy of NISSAN MOTOR CO., U.S.A.
6. Pull out the CVT fluid level gauge from the CVT fluid charging pipe after pressing the tab on the CVT fluid level gauge to release the lock.
   Fig 2: Identifying CVT Fluid Charging Pipe

   Courtesy of NISSAN MOTOR CO., U.S.A.
7. Wipe fluid off the CVT fluid level gauge. Insert the CVT fluid level gauge rotating 180° from the originally installed position, then securely push the CVT fluid level gauge until it meets the top end of the CVT fluid charging pipe.
   CAUTION: When wiping away the CVT fluid level gauge, always use lint-free paper, not a cloth rag.
   Fig 3: Inserting CVT Fluid Level Gauge

   Courtesy of NISSAN MOTOR CO., U.S.A.
8. Place the selector lever in "P" or "N" and check that the fluid level is within the specified range.
   CAUTION: When reinstalling CVT fluid level gauge, insert it into the CVT fluid charging pipe and rotate it to the original installation position until securely locked.
   Fig 4: Identifying CVT Fluid Level Gauge Range

   Courtesy of NISSAN MOTOR CO., U.S.A.