LEMON Manuals: Even more car manuals for everyone
Home >> Nissan-Datsun >> 2004 >> Altima S, Standard >> Repair and Diagnosis >> External Pages >> Different car >> Section 1002 (Automatic Transmission (Re0F09B)) >> On-Vehicle Maintenance >> CVT Fluid >> Changing

CVT Fluid: Changing

WARNING: This page is about a different car, the 2009 Nissan Maxima. However, it is still accessible from the selected car via links, so may be relevant.
CAUTION: Replace a O-ring with new ones at the final stage of the operation when installing.
  1. Remove drain plug from oil pan.
  2. Remove O-ring from drain plug.
  3. Install O-ring to drain plug.
    CAUTION: Never reuse O-ring.
  4. Install drain plug to oil pan. Refer to "EXPLODED VIEW ".
  5. Fill CVT fluid from CVT fluid charging pipe to the specified level.

    CVT fluid: Refer to  "GENERAL SPECIFICATION ".

    Fluid capacity: Refer to  "GENERAL SPECIFICATION ".

    CAUTION:
    • Use only Genuine NISSAN CVT Fluid NS-2. Never mix with other fluid.
    • Using CVT fluid other than Genuine NISSAN CVT Fluid NS-2 will deteriorate in driveability and CVT durability, and may damage the CVT, which is not covered by the warranty.
    • When filling CVT fluid, take care not to scatter heat generating parts such as exhaust.
    • Sufficiently shake the container of CVT fluid before using.
    • Delete CVT fluid deterioration date with CONSULT-III after changing CVT fluid. Refer to "CONSULT-III FUNCTION (TRANSMISSION) ".
  6. With the engine warmed up, drive the vehicle in an urban area.
    NOTE: When ambient temperature is 20°C (68°F), it takes about 10 minutes for the CVT fluid to warm up to 50 to 80°C (122 to 176°F).
  7. Check CVT fluid level and condition.
  8. Repeat steps 1 to 5 if CVT fluid has been contaminated.
scientia non olet · About LEMON Manuals