CONSULT-III Function (TRANSMISSION): Function
WARNING: This page is about a different car, the 2009 Nissan Maxima. However, it is still accessible from the selected car via links, so may be relevant.
CONSULT-III can display each diagnostic item using the diagnostic test modes shown following.
DIAGNOSTIC TEST MODE CHART
| Diagnostic test mode | Function |
|---|---|
| Work Support | This mode enables a technician to adjust some devices faster and more accurately. |
| Self Diagnostic Results | Retrieve DTC from ECU and display diagnostic items. |
| Data Monitor | Monitor the input/output signal of the control unit in real time. |
| CAN Diagnosis | This mode displays a network diagnosis result about CAN by a diagram. |
| CAN Diagnostic Support Monitor | It monitors the status of CAN communication. |
| Function Test | This mode can show results of self-diagnosis of ECU with either "OK" or "NG". For engine, more practical tests regarding sensors/switches and/or actuators are available. |
| ECU Identification | Display the ECU identification number (part number etc.) of the selected system. |
| Special Function | Other results or histories, etc. that are recorded in ECU are displayed. |