Data Monitor Mode
WARNING: This page is about a different car, the 2009 Nissan Maxima. However, it is still accessible from the selected car via links, so may be relevant.
Display Items List
DISPLAY ITEM LIST
| X: Standard, -: Not applicable, : Option | ||||
|---|---|---|---|---|
| Monitored item (Unit) | Monitor item selection | Remarks | ||
| ECU INPUT SIGNALS | MAIN SIGNALS | SELECTION FROM MENU | ||
| VSP SENSOR (km/h) | X | - | Output speed sensor (secondary speed sensor) | |
| ESTM VSP SIG (km/h) | X | - | - | |
| PRI SPEED SEN (RPM) | X | - | - | |
| ENG SPEED SIG (RPM) | X | - | - | |
| SEC HYDR SEN (V) | X | - | - | |
| PRI HYDR SEN (V) | X | - | - | |
| ATF TEMP SEN (V) | X | - | CVT fluid temperature sensor | |
| VIGN SEN (V) X | - | -- | VEHICLE SPEED (km/h or mph) - X Vehicle speed recognized by the TCM. | |
| PRI SPEED (RPM) | - | X | Primary pulley speed | |
| SEC SPEED (RPM) | - | - | Secondary pulley speed | |
| ENG SPEED (RPM) | - | X | - | |
| SLIP REV (RPM) | - | X | Difference between engine speed and primary pulley speed. | |
| GEAR RATIO | - | X | - | |
| G SPEED (G) | - | - | - | |
| ACC PEDAL OPEN (0.0/8) | X | X | Degree of opening for accelerator recognized by the TCM. For fail-safe operation, the specific value used for control is displayed. |
|
| TRQ RTO | - | - | - | |
| SEC PRESS (MPa) | - | X | - | |
| PRI PRESS (MPa) | - | X | - | |
| ATFTEMP COUNT | - | X | Means CVT fluid temperature. Actual oil temperature °C (°F) cannot be checked unless a numeric value is converted. Refer to OBD-II SELF-DIAGNOSIS . | |
| DSR REV (RPM) | - | - | - | |
| DGEAR RATIO | - | - | - | |
| DSTM STEP (step) | - | - | - | |
| STM STEP (step) | - | X | - | |
| LU PRS (MPa) | - | - | - | |
| LINE PRS (MPa) | - | - | - | |
| TGT SEC PRESS (MPa) | - | - | - | |
| ISOLT1 (A) | - | X | Torque converter clutch solenoid valve output current | |
| ISOLT2 (A) | - | X | Pressure control solenoid valve A (line pressure solenoid valve) output current | |
| ISOLT3 (A) | - | X | Pressure control solenoid valve B (secondary pressure solenoid valve) output current | |
| SOLMON1 (A) | X | X | Torque converter clutch solenoid valve monitor current | |
| SOLMON2 (A) | X | X | Pressure control solenoid valve A (line pressure solenoid valve) monitor current | |
| SOLMON3 (A) | X | X | Pressure control solenoid valve B (secondary pressure solenoid valve) monitor current | |
| INH SW3M (On/Off) | X | - | PNP switch 3 ON-OFF status monitor | |
| INH SW4 (On/Off) | X | - | PNP switch 4 ON-OFF status | |
| INH SW3 (On/Off) | X | - | PNP switch 3 ON-OFF status | |
| INH SW2 (On/Off) | X | - | PNP switch 2 ON-OFF status | |
| INH SW1 (On/Off) | X | - | PNP switch 1 ON-OFF status | |
| BRAKE SW (On/Off) | X | X | Stop lamp switch (signal input via CAN communications) | |
| FULL SW (On/Off) | X | X | Signal input via CAN communications | |
| IDLE SW (On/Off) | X | X | ||
| SPORT MODE SW (On/Off) | X | X | Not mounted but displayed. | |
| STRDWNSW (On/Off) | X | - | Responds only to vehicles with addle shifter | |
| STRUPSW (On/Off) | X | - | ||
| DOWNLVR (On/Off) | X | - | Responds only to vehicles with manual mode | |
| UPLVR (On/Off) | X | - | ||
| NONMMODE (On/Off) | X | - | ||
| MMODE (On/Off) | X | - | ||
| INDLRNG (On/Off) | - | - | - | |
| INDDRNG (On/Off) | - | - | "D" position indicator output | |
| INDNRNG (On/Off) | - | - | "N" position indicator output | |
| INDRRNG (On/Off) | - | - | "R" position indicator output | |
| INDPRNG (On/Off) | - | - | "P" position indicator output | |
| CVT LAMP (On/Off) | - | - | - | |
| SPORT MODE IND (On/Off) | - | - | Not mounted but displayed. | |
| MMODE IND (On/Off) | - | - | - | |
| SMCOIL D (On/Off) | - | - | Step motor coil "D" energizing status | |
| SMCOIL C (On/Off) | - | - | Step motor coil "C" energizing status | |
| SMCOIL B (On/Off) | - | - | Step motor coil "B" energizing status | |
| SMCOIL A (On/Off) | - | - | Step motor coil "A" energizing status | |
| LUSEL SOL OUT (On/Off) | - | - | - | |
| REV LAMP (On/Off) | - | X | - | |
| STRTR RLY OUT (On/Off) | - | - | Starter relay | |
| LUSEL SOL MON (On/Off) | - | - | - | |
| STRTR RLY MON (On/Off) | - | - | Starter relay monitor | |
| VDC ON (On/Off) | X | - | - | |
| TCS ON (On/Off) | X | - | - | |
| ABS ON (On/Off) | X | - | - | |
| ACC ON (On/Off) | X | - | Not mounted but displayed. | |
| RANGE | - | X | Indicates position is recognized by TCM. Indicates a specific value required for control when fail-safe function is activated. | |
| M GEAR POS | - | X | Not mounted but displayed. | |
| Voltage (V) | - | - | Displays the value measured by the voltage probe. | |
| Frequency (Hz) | - | - | The value measured by the pulse probe is displayed. | |
| DUTY-HI (high) (%) | - | - | ||
| DUTY-LOW (low) (%) | - | - | ||
| PLS WIDTH-HI (ms) | - | - | ||
| PLS WIDTH-LOW (ms) | - | - | ||