DTC Confirmation Procedure
WARNING: This page is about a different car, the 2009 Nissan Maxima. However, it is still accessible from the selected car via links, so may be relevant.
CAUTION:
Always drive vehicle at a safe speed.
NOTE:
Immediately after performing any "DTC CONFIRMATION PROCEDURE", always turn ignition switch OFF. Then wait at least 10 seconds before performing the next test.
- CHECK DTC DETECTION
With CONSULT-III
- Start engine.
- Drive vehicle for at least 5 consecutive seconds.
- Perform "Self Diagnostic Results" in "TRANSMISSION".
With GST
Follow the procedure "With CONSULT-III".
Is "P1777 STEP MOTR CIRC" detected?
YES: Go to "DIAGNOSIS PROCEDURE ".
NO: Refer to "INTERMITTENT INCIDENT ".