DTC Confirmation Procedure

WARNING: This page is about a different car, the 2009 Nissan Maxima. However, it is still accessible from the selected car via links, so may be relevant.

CAUTION: Always drive vehicle at a safe speed.

NOTE: Immediately after performing any "DTC CONFIRMATION PROCEDURE", always turn ignition switch OFF. Then wait at least 10 seconds before performing the next test.

CHECK DTC DETECTION
With CONSULT-III
1. Turn ignition switch ON.
2. Select "Data Monitor" in "TRANSMISSION".
3. Start engine and maintain the following conditions for at least 5 consecutive seconds.
  RANGE: "D" and "N" position
  
  (At each time, wait for 5 seconds.)
  
  With GST
  
  Follow the procedure "With CONSULT-III".
Is "P1740 LU-SLCT SOL/CIRC" detected?

YES: Go to "DIAGNOSIS PROCEDURE ".

NO: Refer to "INTERMITTENT INCIDENT ".