DTC Confirmation Procedure
WARNING: This page is about a different car, the 2009 Nissan Maxima. However, it is still accessible from the selected car via links, so may be relevant.
NOTE:
Immediately after performing any "DTC CONFIRMATION PROCEDURE", always turn ignition switch OFF. Then wait at least 10 seconds before performing the next test.
- CHECK DTC DETECTION
With CONSULT-III
- Turn ignition switch ON.
- Depress accelerator pedal fully and release it, then wait for 5 seconds.
- Perform "Self Diagnostic Results" in "TRANSMISSION".
Is "P1705 TP SEN/CIRC A/T" detected?
YES: Go to "DIAGNOSIS PROCEDURE ".
NO: Refer to "INTERMITTENT INCIDENT ".