LEMON Manuals: Even more car manuals for everyone
Home >> Nissan-Datsun >> 2004 >> Altima S, Standard >> Repair and Diagnosis >> External Pages >> Different car >> Section 1002 (Automatic Transmission (Re0F09B)) >> Component Diagnosis >> P0841 Pressure Sensor Function >> DTC Logic >> DTC Confirmation Procedure

DTC Confirmation Procedure

WARNING: This page is about a different car, the 2009 Nissan Maxima. However, it is still accessible from the selected car via links, so may be relevant.
CAUTION: Always drive vehicle at a safe speed.
NOTE: Immediately after performing any "DTC CONFIRMATION PROCEDURE", always turn ignition switch OFF. Then wait at least 10 seconds before performing the next test.
  1. CHECK DTC DETECTION

    With CONSULT-III

    1. Turn ignition switch ON.
    2. Select "Data Monitor" in "TRANSMISSION".
    3. Start engine and maintain the following conditions for at least 12 consecutive seconds.

    VEHICLE SPEED: 40 km/h (25 MPH) or more

    RANGE: "D" position

    Is "P0841 PRESS SEN/FNCTN" detected? 

    YES: Go to "DIAGNOSIS PROCEDURE ".

    NO: Refer to "INTERMITTENT INCIDENT ".

scientia non olet · About LEMON Manuals