Component Inspection (Manual Mode Switch)

WARNING: This page is about a different car, the 2009 Nissan Maxima. However, it is still accessible from the selected car via links, so may be relevant.

CHECK MANUAL MODE SWITCH

Check continuity between control device connector terminals.

TERMINAL CONTINUITY REFERENCE

Control device connector			Condition	Continuity
Connector	Terminal		Condition	Continuity
M78	5	4	Manual shift gate position	Not existed
	5	4	Other than the above	Existed
	1	4	Manual shift gate position (neutral)	Existed
	1	4	Other than the above	Not existed
	3	4	Selector lever: UP (+ side)	Existed
	3	4	Other than the above	Not existed
	2	4	Selector lever: DOWN (- side)	Existed
	2	4	Other than the above	Not existed

Is the inspection result normal?

YES: INSPECTION END

NO: Repair or replace damaged parts.

Fig 1: Checking Continuity Between Control Device Connector Terminals

Courtesy of NISSAN MOTOR CO., U.S.A.