LEMON Manuals: Even more car manuals for everyone
Home >> Nissan-Datsun >> 2004 >> Altima S, Standard >> Repair and Diagnosis >> External Pages >> Different car >> Section 1002 (Automatic Transmission (Re0F09B)) >> Component Diagnosis >> P0746 Pressure Control Solenoid A Performance (Line Pressure Solenoid Valve) >> DTC Logic >> DTC Confirmation Procedure

DTC Confirmation Procedure

WARNING: This page is about a different car, the 2009 Nissan Maxima. However, it is still accessible from the selected car via links, so may be relevant.
CAUTION: Always drive vehicle at a safe speed.
NOTE: Immediately after performing any "DTC CONFIRMATION PROCEDURE", always turn ignition switch OFF. Then wait at least 10 seconds before performing the next test.
  1. CHECK DTC DETECTION

    With CONSULT-III

    1. Turn ignition switch ON.
    2. Select "Data Monitor" in "TRANSMISSION".
    3. Start engine and maintain the following conditions for at least 10 consecutive seconds. Test start from 0 km/h (0 MPH).

    ATF TEMP SEN: 1.0 - 2.0 V

    ACC PEDAL OPEN: More than 1.0/8

    RANGE: "D" position

    VEHICLE SPEED: 10 km/h (6 MPH) or more

    Driving location: Driving the vehicle uphill (increased engine load) will help maintain the driving conditions required for this test.

    With GST

    Follow the procedure "With CONSULT-III".

    Is "P0746 PRS CNT SOL/A FCTN" detected? 

    YES: Go to "DIAGNOSIS PROCEDURE ".

    NO: Refer to "INTERMITTENT INCIDENT ".

scientia non olet · About LEMON Manuals