DTC Confirmation Procedure

WARNING: This page is about a different car, the 2009 Nissan Maxima. However, it is still accessible from the selected car via links, so may be relevant.

CAUTION: Always drive vehicle at a safe speed.

NOTE: Immediately after performing any "DTC CONFIRMATION PROCEDURE", always turn ignition switch OFF. Then wait at least 10 seconds before performing the next test.

CHECK DTC DETECTION (PART 1)
With CONSULT-III
1. Turn ignition switch ON.
2. Select "Data Monitor" in "TRANSMISSION".
3. Check that output voltage of CVT fluid temperature sensor is within the range specified below.
ATF TEMP SEN: 0.16 - 2.03 V

is the inspection result normal?

YES: Refer to "INTERMITTENT INCIDENT ".

NO-1 ("ATF TEMP SEN" indicates 0.15 or less.): Refer to "DIAGNOSIS PROCEDURE ".

NO-2 ("ATF TEMP SEN" indicates 2.04 or more.): GO TO 2.
CHECK DTC DETECTION (PART 2)
With CONSULT-III
1. Turn ignition switch ON.
2. Select "Data Monitor" in "TRANSMISSION".
3. Start engine and maintain the following conditions for at least 14 minutes.
  RANGE: "D" position
  
  VEHICLE SPEED: 10 km/h (6 MPH) or more
  
  With GST
  
  Follow the procedure "With CONSULT-III".
Is "P0710 ATF TEMP SEN/CIRC" detected?

YES: Go to "DIAGNOSIS PROCEDURE ".

NO: Refer to "INTERMITTENT INCIDENT ".