DTC Confirmation Procedure

WARNING: This page is about a different car, the 2009 Nissan Maxima. However, it is still accessible from the selected car via links, so may be relevant.

CAUTION: Always drive vehicle at a safe speed.

NOTE: Immediately after performing any "DTC CONFIRMATION PROCEDURE", always turn ignition switch OFF. Then wait at least 10 seconds before performing the next test.

CHECK DTC DETECTION
With CONSULT-III
1. Turn ignition switch ON.
2. Select "Data Monitor" in "TRANSMISSION".
3. Start engine.
4. Drive vehicle and maintain the following conditions for at least 2 consecutive seconds.
  VEHICLE SPEED: More than 10 km/h (6 MPH)
  
  ENG SPEED SIG: More than 450 RPM
  
  ACC PEDAL OPEN: More than 1.0/8
  
  With GST
  
  Follow the procedure "With CONSULT-III".
Is "P0705 PNP SW/CIRC" detected?

YES: Go to "DIAGNOSIS PROCEDURE ".

NO: Refer to "INTERMITTENT INCIDENT ".