LEMON Manuals: Even more car manuals for everyone
Home >> Nissan-Datsun >> 2004 >> Altima S, Standard >> Repair and Diagnosis >> External Pages >> Different car >> Section 1001 (Engine Mechanical) >> On-Vehicle Repair >> Oil Seal >> Removal and Installation of Valve Oil Seal >> Installation

Removal and Installation of Valve Oil Seal: Installation

WARNING: This page is about a different car, the 2009 Nissan Maxima. However, it is still accessible from the selected car via links, so may be relevant.
  1. Apply new engine oil to new valve oil seal joint surface and seal lip.
  2. Press in valve oil seal to height "H" using Tool to specified height.
    Fig 1: Installing Valve Oil Seal
    G04899764Courtesy of NISSAN MOTOR CO., U.S.A.

    Tool number: - (J-39386) 

    NOTE: Dimension "H": height measured before valve spring seat installation.

    Intake and exhaust: 14.3 - 14.9 mm (0.563 - 0.587 in) 

  3. Installation of the remaining components is in the reverse order of removal.
scientia non olet · About LEMON Manuals