LEMON Manuals: Even more car manuals for everyone
Home >> Nissan-Datsun >> 2004 >> Altima S, Standard >> Repair and Diagnosis >> External Pages >> Different car >> Section 1001 (Engine Mechanical) >> On-Vehicle Repair >> Oil Seal >> Removal and Installation of Rear Oil Seal >> Removal

Removal and Installation of Rear Oil Seal: Removal

WARNING: This page is about a different car, the 2009 Nissan Maxima. However, it is still accessible from the selected car via links, so may be relevant.
  1. Remove engine and CVT assembly. Refer to "REMOVAL AND INSTALLATION ".
  2. Separate the CVT from the engine assembly. Refer to "REMOVAL AND INSTALLATION ".
  3. Remove drive plate. Refer to "DOWEL PIN ALIGNMENT ".
  4. Remove rear oil seal retainer using Tool.
    Fig 1: Removing Rear Oil Seal Retainer
    G04886102Courtesy of NISSAN MOTOR CO., U.S.A.

    Tool Number: KV10111100 (J-37228) 

    CAUTION:
    • Be careful not to damage mating surface.
    • If rear oil retainer is removed, replace it with a new one
scientia non olet · About LEMON Manuals