Removal and Installation of Rear Oil Seal: Installation

WARNING: This page is about a different car, the 2009 Nissan Maxima. However, it is still accessible from the selected car via links, so may be relevant.

Remove old liquid gasket material from mating surface of cylinder block and oil pan using a suitable scraper.
Apply liquid gasket to the new rear oil seal retainer using suitable tool.

Fig 1: Identifying Liquid Gasket Applying Area
Courtesy of NISSAN MOTOR CO., U.S.A.
- Use Genuine Silicone RTV Sealant or equivalent. Refer to "RECOMMENDED CHEMICAL PRODUCTS AND SEALANTS ".
- Assembly should be completed within 5 minutes after coating.
Installation is in the reverse order of removal.
CAUTION:
- When replacing an engine or transmission you must make sure the dowels are installed correctly during re-assembly.
- Improper alignment caused by missing dowels may cause vibration, oil leaks or breakage of drivetrain components.