LEMON Manuals: Even more car manuals for everyone
Home >> Nissan-Datsun >> 2003 >> Sentra SE-R, Automatic >> Repair and Diagnosis (Single Page) >> Engine Mechanical >> Engine Mechanical - Qr25DE >> Camshaft >> Removal and Installation >> Inspection After Removal >> Camshaft Runout

Camshaft Runout

  1. Put the camshaft on a V-block supporting the No. 2 and No. 5 journals.
    Fig 1: Measuring Camshaft Runout Using Dial Gauge
    G02007818Courtesy of NISSAN MOTOR CO., U.S.A.
  2. Set the dial gauge vertically on the No. 3 journal.
  3. Turn camshaft in one direction by hand, and measure the camshaft runout on the dial gauge total indicator reading.

    Standard: Less than 0.04 mm (0.0016 in) 

scientia non olet · About LEMON Manuals