LEMON Manuals: Even more car manuals for everyone
Home >> Nissan-Datsun >> 2003 >> Sentra SE-R, Automatic >> Repair and Diagnosis (Single Page) >> Body & Frame >> Door Locks >> NVIS (NISSAN Vehicle Immobilizer System-NATS) >> NVIS (NISSAN Vehicle Immobilizer System - NATS) >> Wiring Diagram - NATS - >> Consult-II >> Consult-II Inspection Procedure

Consult-II Inspection Procedure

  1. Turn ignition switch OFF.
    Fig 1: Connecting CONSULT-II To Data Link Connector
    G01333063Courtesy of NISSAN MOTOR CO., U.S.A.
  2. Connect "CONSULT-II" to data link connector.
  3. Insert NVIS (NATS) program card into CONSULT-II.

    Program card: NATS (AEN00A) 

    Fig 2: CONSULT-II Display - Touch "START"
    G01333064Courtesy of NISSAN MOTOR CO., U.S.A.
  4. Turn ignition switch ON.
  5. Touch "START".
  6. Select "NATS V.5.0".
    Fig 3: CONSULT-II Display - Select NATS V.5.0
    G01333065Courtesy of NISSAN MOTOR CO., U.S.A.
  7. Perform each diagnostic test mode according to each service procedure.
    Fig 4: CONSULT-II Display - Diagnostic Test Mode Display
    G01333066Courtesy of NISSAN MOTOR CO., U.S.A.

    For further Information, see the "CONSULT-II OPERATION MANUAL IVIS/NVIS". 

scientia non olet · About LEMON Manuals