High Beam Operation/Flash-to-pass Operation

When the lighting switch is moved to headlamp "ON" (2ND) position, "HIGH BEAM" (A) or "FLASH TO PASS" (C) position, power is supplied:

• From lighting switch terminal 6
• To RH headlamp terminal HI, and
• From lighting switch terminal 9
• To daytime light control unit terminal 5, and
• To combination meter terminal 2 (with tachometer), 12 (without tachometer) for the high beam indicator
• Through daytime light control unit terminal 6
• To LH headlamp terminal HI.

  Ground is supplied in the same manner as low beam operation.

  Ground is supplied to terminal 3 (with tachometer), 14 (without tachometer) of the combination meter through body grounds M28 and M54.

  With power and ground supplied, the high beam headlamps and high beam indicator illuminate.