"Key Warn ALM"/"Light Warn ALM"/"Seat Belt ALM"

1. Turn ignition switch OFF.
2. Connect "CONSULT-II" to the data link connector.
   Fig 1: Locating Data Link Connector

   Courtesy of NISSAN MOTOR CO., U.S.A.
3. Turn ignition switch ON.
4. Touch "START"
   Fig 2: CONSULT-II Display - START

   Courtesy of NISSAN MOTOR CO., U.S.A.
5. Touch "SMART ENTRANCE".
   Fig 3: CONSULT-II Display - SMART ENTRANCE

   Courtesy of NISSAN MOTOR CO., U.S.A.
6. Touch "KEY WARN ALM", "LIGHT WARN ALM" or "SEAT BELT ALM".
   Fig 4: CONSULT-II Display - KEY WARN ALM, LIGHT WARN ALM And SEAT BELT ALM

   Courtesy of NISSAN MOTOR CO., U.S.A.
7. Select diagnosis mode.

"DATA MONITOR" and "ACTIVE TEST" are available for the warning chime.

Fig 5: CONSULT-II Display - ACTIVE TEST

Courtesy of NISSAN MOTOR CO., U.S.A.