Intake Manifold

WARNING: This page is about a different car, the 2003 Nissan Pathfinder. However, it is still accessible from the selected car via links, so may be relevant.

Loosen in reverse order and tighten in numerical order shown in the figure.
1. Tighten all bolts and nuts to 4.9 to 9.8 N.m (0.5 to 1.0 kg-m, 44 to 86 in-lb).
2. Finally tighten all bolts and nuts to 26.5 to 31.4 N.m (2.7 to 3.2 kg-m, 20 to 23 ft-lb).
Tighten all bolts and nuts to the final torque, evenly dividing the tightening into at least three steps.

Fig 1: Identifying Tightening Procedures (Intake Manifold)
Courtesy of NISSAN MOTOR CO., U.S.A.