LEMON Manuals: Even more car manuals for everyone
Home >> Nissan-Datsun >> 2003 >> Sentra Limited >> Repair and Diagnosis >> External Pages >> Different car >> Section 798 (Automatic Air Conditioner) >> Blower Unit >> Removal and Installation >> Removal

Removal and Installation: Removal

WARNING: This page is about a different car, the 2003 Nissan Altima. However, it is still accessible from the selected car via links, so may be relevant.
  1. Remove the glove box assembly. Refer to "GLOVE BOX "
  2. Remove the ECM.
  3. Disconnect the blower motor, intake door motor and fan control amp. connector.
  4. Remove the 2 bolts and 1 screw from the blower unit, then remove it.
    Fig 1: Locating Blower Unit Bolts And Screw
    G02162539Courtesy of NISSAN MOTOR CO., U.S.A.
scientia non olet · About LEMON Manuals