LEMON Manuals: Even more car manuals for everyone
Home >> Nissan-Datsun >> 2003 >> Sentra Limited >> Repair and Diagnosis >> External Pages >> Different car >> Section 794 (Sun Roof) >> Sunroof >> Removal and Installation >> Sunroof Unit >> Installation

Sunroof Unit: Installation

WARNING: This page is about a different car, the 2003 Nissan Altima. However, it is still accessible from the selected car via links, so may be relevant.
  1. Temporarily tighten the mounting bolts on the rear sunroof brackets.
  2. Bring sunroof unit into passenger compartment and place the rear end of the rail onto the rear sunroof brackets.
  3. Temporarily tighten the mounting bolts on the front end.
  4. Tighten the installation point bolts diagonally excluding the installation point of the sunroof bracket around the roof opening.
  5. Tighten the bolts on the front sunroof bracket at the vehicle side, and then at the rail side.
  6. Tighten the bolts on the rear sunroof bracket at the vehicle side, and then at the rail side.
    1. Sunroof assembly mounting bolts. 
    2. Sunroof assembly side front end bolts :5.1 - 6.47 N-m) (0.52 - 0.66 kg-m, 46 - 57 in-lb) 
    3. Sunroof assembly side rail bolts :5.1 - 6.47 N-m (0.52 - 0.66 kg-m, 46 - 57 in-lb) 
    4. Sunroof assembly front bracket bolts :5.1 - 6.47 N-m (0.52 - 0.66 kg-m, 46 - 57 in-lb) 
    5. Sunroof assembly rear bracket bolts :5.1 - 6.47 N-m (0.52 - 0.66 kg-m, 46 - 57 in-lb) 
  7. Install sunroof motor switch bracket.
  8. Connect drain hoses.
  9. Install headlining. Refer to "HEADLINGS ".
scientia non olet · About LEMON Manuals