Glass Lid: Installation
WARNING: This page is about a different car, the 2003 Nissan Altima. However, it is still accessible from the selected car via links, so may be relevant.
- Position glass lid to sunroof assembly.
- Tighten glass lid assembly bolts to specification. (First tighten left front bolt, then tighten right rear bolt on glass lid to prevent lid from moving while tightening other bolts.)
- Glass lid assembly mounting bolts :3.0 - 5.0 N-m (0.3 - 0.5 kg-m, 26 - 43 in-lb)
- Position and push trim into place.
- After installation, perform fitting adjustment.