LEMON Manuals: Even more car manuals for everyone
Home >> Nissan-Datsun >> 2003 >> Sentra Limited >> Repair and Diagnosis >> External Pages >> Different car >> Section 783 (Clutch) >> Clutch Master Cylinder >> Removal and Installation >> Installation

Removal and Installation: Installation

WARNING: This page is about a different car, the 2003 Nissan Altima. However, it is still accessible from the selected car via links, so may be relevant.
  1. Connect the clutch tube to the master cylinder assembly, and hand-tighten the flare nut.
  2. Install the master cylinder assembly, and tighten the nuts to specification.
    1. Clutch master cylinder nuts : 7.8 - 10.8 .m (0.8 - 1.1 kg-m, 69 - 95 in-lb) 
  3. Install the clutch reservoir tank and bracket, tighten the reservoir tank and bracket nuts and bolts to specification.
    1. Reservoir tank and bracket nuts and bolts : 5.1 - 6.5 N.m (0.52 - 0.66 kg-m, 45.1 - 57.3 in-lb) 
  4. Tighten the clutch tube flare nut to specification using a flare nut torque wrench.
    1. Clutch tube flare nut : 15 - 18 N.m (1.5 - 1.8 kg-m, 11 - 13 ft-lb) 
  5. After installing the clevis pin, install the snap pin to connect the clutch pedal to the push rod. Then bleed the air from the clutch hydraulic system. Refer to "AIR BLEEDING PROCEDURE ".
scientia non olet · About LEMON Manuals