Removal and Installation: Removal

WARNING: This page is about a different car, the 2003 Nissan Altima. However, it is still accessible from the selected car via links, so may be relevant.

Drain coolant.
CAUTION: Perform when the engine is cold.
Remove the following parts:
- Undercover, using power tools.
- Alternator, water pump and air compressor drive belt.
- Engine cover and coolant reservoir.
- IPDM E/R (set aside). Refer to REMOVAL AND INSTALLATION OF IPDM E/R .
- Front passenger side wheel and tire, and splash shield.
- Engine ground.
Remove the water pump.
NOTE: If necessary, the alternator and exhaust manifold catalytic convertor assembly must be removed to remove the water pipe.
CAUTION:
- Handle the water pump vane so that it does not contact any other parts.
- Water pump cannot be disassembled and should be replaced as an assembly.